Orifice T Tool Part# 039 009 $29.99

The Orifice T-Tool is used to install/remove the standard slotted orifice used in most diving industry second stages*. The tool body is machined from cold roll steel and a dowel pin is pressed into the driver end to hold the orifice stable while it is being installed. This assembly of the body and the pin is done prior to plating so that the entire unit can be protected by the nickel chrome finish. The cross tee handle is a stainless steel tension pin that is set in from the end of the tool to allow the tool to be freely rotated by the thumb and index finger (see photo).
The Orifice T-Handle eliminates the problem of scratching the internal o'ring land of the regulator air barrel and replaces the stubby screwdriver normally used to do this job. The machined shoulder above the driver bit fits the internal bore of the air barrel providing the proper alignment while the driver is engaged with the orifice.